Langkah-langkah atau Cara Mengkonfigurasi jaringan menggunakan 2 router di Packet Tracer
Rancagan jaringan menggunakan 2 router....
Cara pertma Isikan IP Address pada PC lalu hubungkan PC k Switch dengan menggunakan kabel staright, PC-router menggunakan kabel Staright, Router-router menggunakan kabel serial.....
Setelah itu klik pada router0 dan ikuti langkah-langkah dibawah ini..... :) :D
Cara pertma Isikan IP Address pada PC lalu hubungkan PC k Switch dengan menggunakan kabel staright, PC-router menggunakan kabel Staright, Router-router menggunakan kabel serial.....
Setelah itu klik pada router0 dan ikuti langkah-langkah dibawah ini..... :) :D
ROUTER 0
Router>enable
Router#configure
terminal
Enter
configuration commands, one per line.
End with CNTL/Z.
Router(config)#hostname
one
one(config)#enable
password one
one(config)#interface
fastEthernet 0/0
one(config-if)#ip
address 192.168.1.1 255.255.255.240
one(config-if)#no
shutdown
one(config-if)#no
shutdown
%LINK-5-CHANGED:
Interface FastEthernet0/0, changed state to up
%LINEPROTO-5-UPDOWN:
Line protocol on Interface FastEthernet0/0, changed state to up
one(config-if)#exit
one(config)#
one(config)#interface
serial 2/0
one(config-if)#ip
address 192.168.0.1 255.255.255.240
one(config-if)#clock
rate 64000
one(config-if)#no
shutdown
%LINK-5-CHANGED:
Interface Serial2/0, changed state to down
one(config-if)#exit
one(config)#ip
route 10.10.10.0 255.255.255.240 192.168.0.2
%LINK-5-CHANGED:
Interface Serial2/0, changed state to down
one(config)#exit
one#write
Building
configuration . . .
[OK]
ROUTER 1
Router>enable
Router#configure
terminal
Enter
configuration commands, one per line.
End with CNTL/Z.
Router(config)#hostname
two
two(config)#enable
password two
two(config)#interface
fastEthernet 1/0
two(config-if)#ip
address 10.10.10.1 255.240.0.0
two(config-if)#no
shutdown
%LINK-5-CHANGED:
Interface FastEthernet1/0, changed state to up
%LINEPROTO-5-UPDOWN:
Line protocol on Interface FastEthernet1/0, changed state to up
two(config-if)#exit
two(config)#interface
serial 2/0
two(config-if)#ip
address 192.168.0.2 255.255.255.240
two(config-if)#clock
rate 64000
two(config-if)#no
shutdown
%LINK-5-CHANGED:
Interface Serial3/0, changed state to up
two(config-if)#
%LINEPROTO-5-UPDOWN:
Line protocol on Interface Serial3/0, changed state to up
two(config-if)#exit
two(config)#
two(config)#ip
route 192.168.1.0 255.255.255.252 192.168.0.1
two(config)#exit
two#write
Building
configuration . . .
[OK]
Percobaan
test ping dari PC0 ke PC4 dengan kelas yang berbeda…...coba lihat diatas...
Test ping dari PC5
ke PC1…..
